Brake cable endclip, fits al brake cable what we sell.

140mm diameter precision ground brake rotor.

For use with the billet front wheel (060836) and Hub Wheel Set (010800)

Go-ped 6,5" CNC Rim (Disc) Set + CNC Hub Set to run pocketbike style Rims with Racing Tires.

Fits GSR Cruiser, GSR26, GSR29, GSR40, GSR46R, GSR Interceptor, Pro60, GTR Roadster and GTR Interceptor.

Front hub and rear adaptor have 6 bolt IS pattern for mountain brake rotor (041122). The rear sprocket mounts using the same holes as the stock wheel, allowing you to use any of the GSR rear sprocket sizes. Includes front and rear hubs, sprocket to rotor adaptor, bearings, center spacers, axle spacers, hardware and two CNC Rims with Valve for front and rear. The Spacer for the rear Fender to get more place from tyre to fender is include to. Rim sice 2,1" - 6,5" - 99 and 2,3" - 6,5 - 130.

To drive now with this Kit you need two Tyres (010903) and two Brake Disc (041122)

Velocity Choke assembly with 3/4" thru hole for velocity stack. Works with al V-stack (30,5mm from center to center bolt spread). 

This is the first Choke System with new Rubber Cord on outside of the Choke. This guarantee the engine don´t received parasitic air-

This Velocity Choke is fit for many WYK, WT, HDA an so on Walbro Carburetor Series.

Note: Only with this choke you cannot mounting an performance filter. You need the velocity stack (010420)

Note: Order the velocity stack gasket (011212) for maximum power.

Made in Germany!

Aluminum motor mount and clutch assembly for the GSR25, GSR26R, GSR29R, GSR Sport, Go-Quad 25, Go-Quad 30 and Go-Quad 40. Includes motor mount, clutch drum, bearing, and large and small snap rings.

Part Number: 1054A

Screw locking device middle celebration. To save and fastening of screws and hydraulics thread at vibration. Until normally dismantling destitute of M36. Applying at blind holes also into the drilling. Application area: Universal securing of nuts and screws, for passive surfaces technical characteristics: Temperature resistance: -55° degrees Celsius to +150° degrees Celsius sticking opening: 0,03-0,14 mm and till M36, sturdy after approx. 12 minutes

Polished Billet Wheel
Fit for al California Goped with Air Tire. Including Bearings and Bearings Distance.

Inner snap ring large for 54/78mm clutch drums. Fits all Goped scooters with centrifugal clutches.

Part Number: 1456

Billet inline fuel filter with cleanable screen. Fits 1/8 (3,2mm inside diameter) inch fuel line. Fits Gas Scooter, California Gopeds and al RC Engines.

Billet Chromoly 54mm clutch drum for Go-Ped scooters.  Made from pre-heat treated 4130/4140 then heat treated again with a double temper and black oxide coated.  Vented design for better heat dissipation.  2mm wall thickness.  Includes a new 17mm retaining clip.

Please note that this is a wearable item and it is NOT warranted against wear!  It will wear with use over time.

For reference, the current batch has a heat treat rating of HRC46-47.

Fits GSR Crusier, GSR Sport, GSR25, GSR29, GTR Roadster and SGQ30.